Recovery Procedure
In the event you are unable to access your AP that has been flashed with the FRC® OpenWRT firmware, there is a recovery procedure available to boot to the backup partition. This will restore all settings to the image defaults (as described in Default Settings ) which should allow you to access the device again.
Recovery
Power off router with power switch.
Turn power back on and Power LED will light. As soon as all LEDs turn off (~2s), power off router with power switch
As soon as all LEDs turn off (~2s), power off router with power switch
Turn power back on and Power LED will light. As soon as all LEDs turn off (~2s), power off router with power switch
As soon as all LEDs turn off (~2s), power off router with power switch
Turn power back on and Power LED will light. As soon as all LEDs turn off (~2s), power off router with power switch
As soon as all LEDs turn off (~2s), power off router with power switch
Turn power back on and allow router to fully boot. It should now be booted to the alternate firmware partition
It should now be booted to the alternate firmware partition